Naboo can count the hours of operation for the steam generator and notify the operator when it is necessary to run the limescale cleaning cycle on the steam generator using the special CALOUT cycle.
PRIMARY WARNING MESSAGES
 |
When the CALOUT process is needed, a popup warning appears: “Perform CALOUT by the end of the day”. Press “Start CALOUT” (see next paragraph) to immediately perform CALOUT or press “Ignore” to perform the procedure later (example: at the end of the day). |
 |
Pressing “Ignore” causes the popup to disappear and a green icon to appear in the upper left. Press the icon to make the popup reappear (example: to perform CALOUT at the end of the day). |
 |
If you do not perform CALOUT by the end of the day, the next day the following popup appears: “Boiler maintenance needed, perform CALOUT as soon as possible.” Press “Start CALOUT” (see next paragraph) to immediately perform CALOUT or press “Ignore” to perform the procedure later (example: at the end of the day). |
 |
Pressing “Ignore” causes the popup to disappear and an orange icon to appear in the upper left. Press the icon to make the popup reappear (example: to perform CALOUT at the end of the day). |
 |
If CALOUT is not performed, once the maximum maintenance interval is reach, the following popup appears: “Boiler maintenance needed, perform CALOUT immediately.” |
 |
Pressing “Ignore” causes the popup to disappear and a red icon to appear in the upper left. Press the icon to make the popup reappear. |
 |
WARNING Pressing “Ignore” when the maximum maintenance interval has been exceeded causes the following popup to appear every day at startup: “Routine boiler cleaning not performed within established time frame. Extraordinary maintenance by an authorized technician is required.”
Naboo will continue to operate normally, the CALOUT function is disabled and a service technician is required as soon as possible to reset the CALOUT function. |
PERFORMING THE CALOUT PROCEDURE
 |
When the CALOUT process is needed, a popup warning appears: “Perform CALOUT by the end of the day”. Press “Start CALOUT”. |
 |
Select CALOUT or the desired wash + CALOUT and the washing procedure starts.
The end of the washing program is signalled by a cyclic buzzer and an informative popup.
If there are consistent residues deposited on the drain filter located in the bottom centre of the cooking chamber, clean it to ensure the free flow of water and detergent.
|
Use only the COMBICLEAN detergent and CALFREE descaler or products approved by the manufacturer.