- As this oven is a type Y appliance (oven without power cable and plug), the cable and other hardware needed to make the connection to the electrical power supply must be provided by the installer. The cable must satisfy the requirements indicated in table 1 “General data”. As already mentioned, the oven must be connected to the power supply by way of a multiple pole main isolating switch ensuring a gap between open contacts of at least 3 mm on each pole.
- To access the power terminal block, the oven panel must be removed by unscrewing the fastening screws.
- The cable must be fed in through the clamp from the back. The individual wires are then fastened to the corresponding terminals of the terminal board. The earth wire must be longer than the other wires, so that in the event of the cable being jerked or the clamp broken, the live wires will disconnect first.
Check the efficiency of the isolating switch. - Connect the power cable according to the following diagrams:
3 AC 400 V + N + PE
Terminal block:
3 AC 230 V + PE
Terminal block:
AC 230 V + N + PE (only for Mod. PFEN044)
Terminal block:
The manufacturer shall not be liable for connections different to those indicated in the present diagram.
- The oven must also be bonded equipotentially to other equipment in the kitchen. This connection is made by wiring a conductor of nominal cross section 10 mm2 to the corresponding terminal at the back of the oven, which is marked with the internationally recognized symbol. All appliances in the room are bonded in this way and connected to the earth system of the building.
- The electrical safety of this appliance can be guaranteed only when it is connected correctly to an efficient earth system, in compliance with current standards.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- As all ovens of the series are fitted with an alternating fan motor (clockwise and anticlockwise rotation), there is no need for the fan to rotate in any particular
direction. Simply verify, when commissioning the appliance, that the fan is balanced and rotates freely.